Bay Front Pellet Stove with Ash Pan and Remote Control The E bay front pellet stove is a fully automatic pellet stove with auto ignition and easy to use electronic controls. Model : E. Where to buy. Assembled Width in FAQs Where do I get support for my product? Visit our Support Area for support options. All replacement parts are covered for 1 year from the date of purchase. The integrity of the firebox itself is covered for 3 years from the purchase date.
Some dealers may sell extended warranties. You will need to contact your dealer for assistance if you have purchased one and are outside of the US Stove coverage time frame. No, you cannot burn corn in your pellet stove. The pellet stove was designed and tested for wood pellets only. Burning corn in your stove will void your warranty and may create a safety hazard or cause damage to your stove. Pellet heaters work by using a software driven control board to precisely deliver a pre-determined amount of fuel from the hopper into a burn chamber.
An electric heating element, used only in startup, heats the pellets until they ignite. The combustion blower forces air through the burn chamber and once ignited, it provides an active combustion of the pellets resulting in very little ash. The exhaust and heat pass through one side of air chambers where on the other side, the variable speed room blower gathers the heat and distributes this through the room.
This entire process results in a very clean burning, efficient heating machine for your home. US Stove Company. AP The AP bay front pellet stove is a fully automatic pellet stove with auto ignition and easy to use electronic controls. Model : AP Where to buy. Assembled Width in FAQs Where do I get support for my product? Visit our Support Area for support options. All replacement parts are covered for 1 year from the date of purchase.
Stove Pellet Burning Room Heater; now your next step is to determine where to install your new pellet stove heater. Locate your Pellet Stove Room Heater in a location which meets the requirements of this manual, but in an area where it does not interfere with the house framing, wiring, etc.
Burn Pot: Note: Let the unit cool to room temperature before inspecting the burn pot. Inspect the burn pot regularly to check that the holes have not become plugged. Ash removal is as follows: 1. Clean the heat exchanger tubes see Heat Exchanger Cleaning section — Make sure Pellet Stove is at room temperature before touching 3. This should be used every 2 or 3 days to remove ash build up on the heat exchanger tubes, which can reduce heat transfer.
The handle, for the heat exchanger tube cleaner, is located in front of the vent tubes on front side of heater. The heater will not light. It is normally a faulty circulation fan.
If the circulation fan does not operate, apply volts directly to the circulation fan. If it still does not operate, replace the circulation fan. Heater will not shut off. Stove Pellet Burning Room Heater dealer to obtain any of these parts. Never use substitute materials. Use of non-approved parts can result in poor performance, safety hazards, and will void your Warranty. Key Parts No. Description Qty. Box South Pittsburg, TN Print page 1 Print document 32 pages.
0コメント